Geopsy: H/V and Spectrum Toolboxes

Use

The H/V and Spectrum toolboxes contains all the parameters needed for windowing, processing, grapics appearance, and output destination. It also contains some informations about processing results.

It comprises three tabs, divided in two to three section grouping the same type of parameters. One section comprises four sub-tabs.

Do not forget that each change made in a toolbox is preserved for the next use of this toolbox. It is strongly recommended to verify the parameters in the toolbox before running the windowing or the H/V-Spectrum computation.

Time Tab

• Global time range section: selection of a portion of the signal
• Time windows section
  • General sub-tab: windowing parameters
  • Raw signal sub-tab: anti-triggering parameters for raw signal
  • Filter sub-tab: filter parameters for filetered signal anti-triggering
  • Filtered signal sub-tab: anti-triggering parameters for filtered signal
• Windows section: number of windows

Processing tab

lreight

• Parameters section: processing parameters
• Horizontal components section (optional): the way to deal with horizontal components

Output tab

• Frequency sampling section: parameters on frequency
• Appearance section: automatic output graphics appearance parameters
• Output section: where to save data

Load parameters and start processing

To load windowing and processing parameters from previous processings, or start processing