Difference between revisions of "Geopsy: H/V and Spectrum Toolboxes"
Jump to navigation
Jump to search
| Line 27: | Line 27: | ||
== Processing Tab == | == Processing Tab == | ||
| − | [[Image:HV_SPEC_toolb_process.png|thumb|right| | + | [[Image:HV_SPEC_toolb_process.png|thumb|right|300px|Processing Tab]] |
* [[Geopsy: H/V and Spectum Toolboxes: Processing Tab#Parameters section|Parameters section]]: processing parameters | * [[Geopsy: H/V and Spectum Toolboxes: Processing Tab#Parameters section|Parameters section]]: processing parameters | ||
* [[Geopsy: H/V and Spectum Toolboxes: Processing Tab#Horizontal components section (only available for HV toolbox) |Horizontal components section]] (for H/V spectral ratio only): the way to deal with horizontal components | * [[Geopsy: H/V and Spectum Toolboxes: Processing Tab#Horizontal components section (only available for HV toolbox) |Horizontal components section]] (for H/V spectral ratio only): the way to deal with horizontal components | ||
Revision as of 16:15, 9 January 2013
Use
The H/V and Spectrum toolboxes contain all the parameters needed for windowing, processing, graphics appearance, and output destination. They also contain some information about processing results.
It comprises three tabs (Time, Processing and Output), divided in two to three sections grouping parameters of the same type. Here below, the tabs inside a section are termed sub-tabs .
- Note: changes made in a toolbox are preserved for its next use when closing the signal window or when quitting Geopsy.
It is however strongly recommended to verify the parameters in the toolbox before running the windowing or the H/V-Spectrum computation.
Time Tab
- Global time range section: selection of a portion of the signal
- Time windows section:
- General sub-tab: windowing parameters
- Raw signal sub-tab: anti-triggering parameters for raw signal
- Filter sub-tab: filter parameters for filetered signal anti-triggering
- Filtered signal sub-tab: anti-triggering parameters for filtered signal
- Number of windows section
Main article: Time Tab
Processing Tab
- Parameters section: processing parameters
- Horizontal components section (for H/V spectral ratio only): the way to deal with horizontal components
Main article: Processing tab
Output Tab
- Frequency sampling section: parameters on frequency
- Appearance section: automatic output graphics appearance parameters
- Output section: where to save the results
Main article: Output tab
Load parameters and start processing
To load windowing and processing parameters from previous processing, or start processing 
Main article: Load parameters and start processing
