Difference between revisions of "Dinver: Tools menu"
| Line 1: | Line 1: | ||
This menu lets the user hide or show various tools used along inversions. Closing a tool panel or hiding it with the menu is strictly equivalent. In any case, if a tool is not visible, you can always get it back thanks to this menu. | This menu lets the user hide or show various tools used along inversions. Closing a tool panel or hiding it with the menu is strictly equivalent. In any case, if a tool is not visible, you can always get it back thanks to this menu. | ||
| − | It contains at least three items which | + | It contains at least three items which contents are the same for all inversion modules: |
* Runs | * Runs | ||
* Log | * Log | ||
* Status | * Status | ||
| − | Plus eventually two others for most of the inversion modules which contents | + | Plus eventually two others for most of the inversion modules which contents depend upon the selected module: |
* Targets | * Targets | ||
* Parameters | * Parameters | ||
Revision as of 21:13, 26 November 2008
This menu lets the user hide or show various tools used along inversions. Closing a tool panel or hiding it with the menu is strictly equivalent. In any case, if a tool is not visible, you can always get it back thanks to this menu.
It contains at least three items which contents are the same for all inversion modules:
- Runs
- Log
- Status
Plus eventually two others for most of the inversion modules which contents depend upon the selected module:
- Targets
- Parameters
Runs is a table that gathers all runs created so far in the environment. This is the master table where you can select runs. This selection is used by menus View and Runs.
Log has one tab per inversion run plus a general tab. All outputs generated during initialization and during inversion itself are stored there with one log per run. This is the good place to look for when you encounter errors or unexpected behaviors.
Status shows dynamic information about running inversion.
