H/V tool

[zhaopeng]

Hi Marc,
I am a newbie and have just downloaded this software. I wanted to use this software for H/V calculation, but I imported the data and set the header for each data.
But I clicked the H/V tool, and nothing happened. I'd like to know how to solve this problem.

Thank you very much.

Peng Zhao

[admin]

Hi Peng,

Did you try to put all three signals in a single viewer? You can use drag and drop to move signal between viewers. With a graphic, all signals are considered. With a table, you can select a subset and create a new viewer by dropping them to the viewer icon in the toolbar.

Once you have a viewer with the three components you can start H/V tool.

Best regards,

Marc

[zhaopeng]

Hi Macl
I did as you said, but I still can not use the H/V tool, and gave the prompt message.
Kind Regards.
Peng Zhao

[admin]

There is already a toolbox attached to your viewer (TFA). Move your signals to a fresh new viewer. Close the former one and start H/V when the new one is active.

[zhaopeng]

Dear Macl,

I ended the program and started importing data again, but it still didn't work. I don't know what the problem is.

Thank you very much for your patience

Kind Regards
Peng Zhao

[admin]

At the step shown by your last snapshot, what is the error message you get when you select H/V tool in waveform menu or in the toolbar?

[zhaopeng]

Dear Macl,
Thank you for your answer. I find why I can not use the H/V tool. The reason is my data have different station name.

Kind Regards.

Peng Zhao

[admin]

Effectively, they must have the same name and the same X, Y, Z coordinates. Sorry for not noticing it.