Vs models from inversion showing different values from parameterization

This forum is dedicated to discuss all problems and suggestions related to the inversion software
Post Reply
Aniket19061990
Posts: 10
Joined: Sun Jan 24, 2021 11:11 am

Vs models from inversion showing different values from parameterization

Post by Aniket19061990 »

Hello.
I did inversion in DINVER. For that run, i have attached the file of Vs models after inversion(best 100 models) and the .param file. In the parameterization, for all layers, the bottom depth was kept 2.2 to 24 m, still the inversion results show some layers having depth beyond 24 m. Why is this happening? Also, in another case, I had restricted Vs from 50 to 800 m/s, but inversion showed some models having Vs near to 2000 m/s. How? This is occurring only when inversions are allowed i.e. Vs1<Vs2 and all such locations are not tick marked.
Attachments
EQDNoAPVs24.txt
(88.43 KiB) Downloaded 22 times
Param_run6.JPG
(44.46 KiB) Not downloaded yet

Post Reply